View source for Disassembling Neo1973/de
From Openmoko
You do not have permission to edit this page, for the following reasons:
You can view and copy the source of this page:
Templates used on this page:
Return to Disassembling Neo1973/de.
You do not have permission to edit this page, for the following reasons:
You can view and copy the source of this page:
Templates used on this page:
Return to Disassembling Neo1973/de.
NOTE: Die Disassembling the Neo1973 page zeigt, wie man die GTA01Bv3 Hardware Revision öffnet. Zukünftige Hardware Revisions können Updates an dieser Anleitung benötigen . Jedoch benutzen das GTA01B4 (wird zur Zeit ausgeliefert) und das GTA02 (die Version die im Oktober veröffentlicht wird) das gleiche Gehäuse. |
Um die Rückabdeckung zu entfernen muss man mit dem Fingernagel vorsichtig in der kleinen Aussparung an der Oberseite des Neo's ziehen.
NOTE: Die beiden Torx Schrauben müssen entfernt werden. (T6x40) |
Um die Frontabdeckung zu entfernen muss man vorsichtig mit dem Gitarren-Plektrum To remove the top cover, after removing the two Torx screws, carefully squeeze the end of the supplied guitar pick between the cover and the case at the bottom of the device, and then slide the pick up to the top on one side (do not twist the pick). As you slide the pick along, the case retaining clips should come apart with a snapping sound. Repeat the procedure for the other side of the device. To unclip the last remaining large retaining clip at the top, slide the pick all the way to the top (this can be difficult) and then press it in at the centre. By careful application of force the clip will detach and the cover can then be removed.
Auf dem Bild sieht man von rechts beginnend im Uhrzeigersinn:
In der Mitte ist das berührungsempfindliche LC-Display (touchscreen) zu sehen. Die Anschluss-Leiterbahnen kann man an der linken unteren Ecke durch das Glas erkennen.
NOTE: Man muss das Kunststoffgehäuse etwas nach außen biegen, damit der Kopfhöreranschluss freigelegt werden kann. |
NOTE: Da die Platine nun auf einer Seite locker ist, kann man den USB-Anschluss und die GPS-Antenne vorsichtig aus der rechten Seite des Gehäuses ziehen und anschließend nach oben klappen. |
Auf dem Bild erkennt man:
Auf der anderen Seite der Platine, von rechts unten nach links unten:
Man kann die beiden Stereo-Lautsprecher unterhalb der durchsichtigen Abdeckung erkennen. Daneben sieht man den kleinen Vibrationsmotor.
Am oberen Ende des Bildes befinden sich Durchbrüche im Gehäuse für die Externe GPS-Antenne und den USB-Anschluss.
Languages: |
English • العربية • Български • Česky • Dansk • Deutsch • Esperanto • Eesti • Español • فارسی • Suomi • Français • עברית • Magyar • Italiano • 한국어 • Nederlands • Norsk (bokmål) • Polski • Português • Română • Русский • Svenska • Slovenčina • Українська • 中文(中国大陆) • 中文(台灣) • Euskara • Català |