View source for Analogue wired Headset Nokia
From Openmoko
You do not have permission to edit this page, for the following reasons:
You can view and copy the source of this page:
Return to Analogue wired Headset Nokia.
You do not have permission to edit this page, for the following reasons:
You can view and copy the source of this page:
Return to Analogue wired Headset Nokia.
The pinout of Nokia Phones is known to use the Nokia-wired-conectivity standard, which is:
This pinout is not compatible to Neo. To use Nokia headphones you have to rewire them swapping Tip and 3. Or use a simple adater doing this swap.
The following sections describe the modifications made to diferent models of headsets by its owners.
Nokia webpage (Mailing list announce).
To reach the PCB you have to remove the bottom black piece of the gray case. It is glued with a soft adhesive, so simply pull out with a fingernail. Below this you can find one of the two screws. The upper black piece is now unlocked, and you only have to remove it to see the second screw. Now you have opened the case. Remember where the knots of the cables are, and pull out the PCB. You have to swap the red and white wires as seen in the picture (click on the image for full size).
You have to change the gain of the output in alsamixer from 80% to 95% due to different sensitivity (dBm/mW) of headphone speakers. Microphone works perfectly. Button may work (not tested).