View source for Disassembling Neo1973/de
From Openmoko
You do not have permission to edit this page, for the following reasons:
You can view and copy the source of this page:
Templates used on this page:
Return to Disassembling Neo1973/de.
You do not have permission to edit this page, for the following reasons:
You can view and copy the source of this page:
Templates used on this page:
Return to Disassembling Neo1973/de.
NOTE: Die Zerlegen des Neo1973 Seite zeigt, wie man die GTA01Bv3 Hardware Revision öffnet. Zukünftige Hardware Revisions können Updates an dieser Anleitung benötigen . Jedoch benutzen das GTA01B4 (wird zur Zeit ausgeliefert) und das GTA02 (die Version die im Oktober veröffentlicht wird) das gleiche Gehäuse. |
Um die Rückabdeckung zu entfernen muss man mit dem Fingernagel vorsichtig in der kleinen Aussparung an der Oberseite des Neo's ziehen.
NOTE: Die beiden Torx Schrauben müssen entfernt werden. (T6x40) |
Um die Frontabdeckung zu entfernen muss man vorsichtig mit dem Gitarren-Plektrum To remove the top cover, after removing the two Torx screws, carefully squeeze the end of the supplied guitar pick between the cover and the case at the bottom of the device, and then slide the pick up to the top on one side (do not twist the pick). As you slide the pick along, the case retaining clips should come apart with a snapping sound. Repeat the procedure for the other side of the device. To unclip the last remaining large retaining clip at the top, slide the pick all the way to the top (this can be difficult) and then press it in at the centre. By careful application of force the clip will detach and the cover can then be removed.
Auf dem Bild sieht man von rechts beginnend im Uhrzeigersinn:
In der Mitte ist das berührungsempfindliche LC-Display (touchscreen) zu sehen. Die Anschluss-Leiterbahnen kann man an der linken unteren Ecke durch das Glas erkennen.
NOTE: You have to bend the plastic case a bit outwards until the headphone jack on the left side of the device becomes loose |
NOTE: Since the PCB now is loose on one side, you can carefully pull the USB socket and GPS antenna connector out of the right side of the case, and then flip the PCB upwards |
This shows:
On the other side of the PCB, going from bottom-right corner down-left.
On the case picture below, you can see the left and right speakers under the translucent plastic, and the vibrator motor in the middle.
You can actually see the two stereo speakers beneath the translucent cover, and next to it the small vibrator motor.
Next to the top of the picture is a hole near the speaker. The external GSM antenna connector is accessed through this hole.
Languages: |
English • العربية • Български • Česky • Dansk • Deutsch • Esperanto • Eesti • Español • فارسی • Suomi • Français • עברית • Magyar • Italiano • 한국어 • Nederlands • Norsk (bokmål) • Polski • Português • Română • Русский • Svenska • Slovenčina • Українська • 中文(中国大陆) • 中文(台灣) • Euskara • Català |