Nand erase

From Openmoko

Revision as of 07:19, 27 December 2007 by Rakshat (Talk | contribs)

Jump to: navigation, search

To make a NAND erase, you need to connect to your device while in uboot using minicom or cu. The device will usually be called /dev/ttyACM0. You might need to

sudo chown uucp.uucp /dev/ttyACM0

to get the necessary right (even as root). Using cu, you can then access the Neo:

cu -l /dev/ttyACM0

After connecting, you should get a prompt where you can tell u-boot to clean certain parts of the NAND memory.

WARNING: Before you hit enter on one of the following commands, make sure that you are *not* issuing a plain "nand erase" command - always make sure you tell it which partition to erase. If you forget this you'll brick the Neo and you'll need a debug board to recover it.


nand erase clean rootfs
nand erase clean kernel

To exit cu you need to type:

~.
Personal tools

To make a NAND erase, you need to connect to your device while in uboot using minicom or cu. The device will usually be called /dev/ttyACM0. You might need to

sudo chown uucp.uucp /dev/ttyACM0

to get the necessary right (even as root). Using cu, you can then access the Neo:

cu -l /dev/ttyACM0

After connecting, you should get a prompt where you can tell u-boot to clean certain parts of the NAND memory.

WARNING: Before you hit enter on one of the following commands, make sure that you are *not* issuing a plain "nand erase" command - always make sure you tell it which partition to erase. If you forget this you'll brick the Neo and you'll need a debug board to recover it.


nand erase clean rootfs
nand erase clean kernel

To exit cu you need to type:

~.