Nand erase
From Openmoko
m (add caveat) |
DolfjeBot1 (Talk | contribs) m (Replacing 'Freerunner' with 'FreeRunner') |
||
Line 9: | Line 9: | ||
After connecting, you should get a prompt where you can tell u-boot to clean certain parts of the NAND memory. | After connecting, you should get a prompt where you can tell u-boot to clean certain parts of the NAND memory. | ||
− | {{warning|Before you hit enter on one of the following commands, make sure that you are *not* issuing a plain "nand erase" command - always make sure you tell it which partition to erase. If you forget this you'll brick the Neo1973 and you'll need a debug board to recover it. For | + | {{warning|Before you hit enter on one of the following commands, make sure that you are *not* issuing a plain "nand erase" command - always make sure you tell it which partition to erase. If you forget this you'll brick the Neo1973 and you'll need a debug board to recover it. For FreeRunner, you can recover using the NOR flash.}} |
nand erase rootfs | nand erase rootfs |
Revision as of 14:45, 31 August 2008
To make a NAND erase, you need to connect to your device while in uboot using minicom or cu. The device will usually be called /dev/ttyACM0. You might need to
sudo chown uucp.uucp /dev/ttyACM0
to get the necessary right (even as root). Using cu, you can then access the Neo:
cu -l /dev/ttyACM0
After connecting, you should get a prompt where you can tell u-boot to clean certain parts of the NAND memory.
WARNING: Before you hit enter on one of the following commands, make sure that you are *not* issuing a plain "nand erase" command - always make sure you tell it which partition to erase. If you forget this you'll brick the Neo1973 and you'll need a debug board to recover it. For FreeRunner, you can recover using the NOR flash. |
nand erase rootfs nand erase kernel
To exit cu you need to type:
~.