Talk:Qtopia / Qt Extended on FreeRunner
From Openmoko
m |
|||
Line 20: | Line 20: | ||
---- | ---- | ||
A problem I had was with "Installing Kernel" instructions : instead of putting uImage.bin on the first partition in /boot folder, I had to put it directly in / (without that I couldn't boot). If someone else can reproduce the problem, I will edit the article. | A problem I had was with "Installing Kernel" instructions : instead of putting uImage.bin on the first partition in /boot folder, I had to put it directly in / (without that I couldn't boot). If someone else can reproduce the problem, I will edit the article. | ||
+ | |||
-Xavier_OM | -Xavier_OM |
Revision as of 10:57, 1 August 2008
Mounting the jffs file as described did not work for me. Instead I did the following:
mknod /dev/mtdblock0 b 31 0
losetup /dev/loop0 <rootfs.jffs2 file>
echo "/dev/loop0" > /sys/module/block2mtd/parameters/block2mtd
mount -t jffs2 /dev/mtdblock0 <mountpoint>
This seemed to work out alright.
-russell
I had pretty good luck with the procedure on the Qtopia on FreeRunner page using KnoppMyth 5.5 for my linux. Had to su but few problems. The only part I didn't figure out was the -C switch in the tar command. Failed every time. Worked around it.
-Pfloyd
A problem I had was with "Installing Kernel" instructions : instead of putting uImage.bin on the first partition in /boot folder, I had to put it directly in / (without that I couldn't boot). If someone else can reproduce the problem, I will edit the article.
-Xavier_OM