-
JTAG communication failure, check connection, JTAG interface, target power etc.
6 KB (494 words) - 11:24, 26 June 2010
-
* Hold in the AUX button on power-up to access the boot menu.
... environment variable to -1 if you want it to always halt at the U-Boot on power-up.
17 KB (2,539 words) - 23:26, 14 April 2012
-
==== Power Supply ====
* If the phone is self-powered, there is no need to connect a power supply for JTAG, USB and serial port, since those are phone-powered
3 KB (522 words) - 14:16, 22 October 2008
-
| [[Neo_1973_GTA01_Power_Management|Power Management]]
* [[Neo1973 Power Button|The Power Button]]
6 KB (924 words) - 08:25, 10 February 2012
-
This information is mostly useful for developers and power/curious users. If you are looking for a kernel to flash into your GTA01/GTA
15 KB (2,540 words) - 16:52, 17 August 2011
-
...stating mistake is to forget to actually activate the CPU. Just connecting power is not enough !
Press and hold the power button until the boot loader does its count-down, or, in case there is no r
8 KB (1,208 words) - 16:43, 10 February 2013
-
* [http://fso-control.projects.openmoko.org/ fso-control] - Popup Power menu to shutdown/suspend/reboot.
22 KB (3,343 words) - 11:41, 12 January 2012
-
... level device control service manages peripheral control, i.e. controlling power for individual subsystems such as
* Backlight brightness and power,
9 KB (1,239 words) - 12:25, 22 October 2008
-
* GTA02v3 power supply flaw found, GTA02v4 needed - DONE
5 KB (709 words) - 11:14, 4 September 2008
-
Some battery power saving mode for not listening to all cell broadcasts.
...o supports this, and how we configure it. It's optional. But we care about power saving!}}
8 KB (1,147 words) - 15:53, 23 November 2011
-
There are times when you wish to power up the device and not power up the gsm/cellphone portion of the phone. For example in meetings you migh
... some cable that would be attached to an openmoko device. In order to save power, one could switch off the gps and only use the bike's sensor.
105 KB (17,388 words) - 17:47, 11 May 2010
-
O Antenna Power On
o Antenna Power Off
10 KB (1,533 words) - 16:19, 8 February 2010
-
This page details the power management of the Phase 1 Neo1973. Much of it is inapplicable to earlier mo
Power management is of utmost concern to any mobile device.
14 KB (2,292 words) - 07:09, 12 September 2010
-
| Silicon Power || SP004GBSTH006V10 || 4GB || 2.0 (SDHC) || Class 4 || ? || ?|| ? || ? ||
| Silicon Power || SP004GBSTH006V30 || 4GB || 2.0 (SDHC) || Class 6 || ? || ?|| ? || ? ||
14 KB (1,712 words) - 17:55, 7 March 2012
-
* If the Neo1973 does not turn on automatically at this point, hold the power button for 5 seconds
...ricked" one will not. Note that there will be no visible feedback from the power-button press on a bricked device.
9 KB (1,491 words) - 08:28, 10 February 2012
-
* power-up the GSM Modem
4 KB (709 words) - 07:40, 19 July 2009
-
...rging logic is embedded into our [[Neo1973 GTA01 Power Management|PCF50606 Power Management]] Unit (PMU).
If more than the available current is drawn from them, they may be reset, or power off.
8 KB (1,355 words) - 08:29, 10 February 2012
-
*Power consumption in various modes - by someone with P1 hardware.
... is to get the following numbers. CPU Idle and max. Backlight power. Audio power max. GSM modem max, normal and off.
2 KB (367 words) - 08:31, 11 October 2007
-
* Power on the Neo. (If it has powered on by itself, that's okay.)
=== power-off while DFU ===
8 KB (1,239 words) - 08:32, 10 February 2012
-
...hes in buildings, with many options including mesh networks and aggressive power saving compared to bluetooth. (Almost no products available.)
...nnecting worn devices. Similar to ZigBee, but much simpler and maybe lower power. ([http://www.thisisant.com/?section=9 Short list] of products.)
56 KB (9,304 words) - 13:52, 6 April 2011
-
* Power (kurz drücken) für Suspend Modus.
2 KB (295 words) - 22:00, 16 February 2010
-
== Power it up ==
...the adapter by clicking on the bluetooth icon in the top bar and selecting power on.
36 KB (5,665 words) - 15:53, 24 July 2010
-
*'''AA or AAA battery''' power options.
...olar-powered mobile]. Using a rugged solar cell (maybe a solar foil) and a power regulating circuit the Neo could be powered ''CO2-neutral''. After all, the
9 KB (1,512 words) - 12:21, 31 August 2008
-
*The Assistance Server has a good satellite signal, and lots of computation power, so it can compare fragmentary signals relayed to it by cell phones, with t
13 KB (2,230 words) - 04:08, 7 October 2008
-
* [http://fso-control.projects.openmoko.org/ fso-control] - Popup Power menu to shutdown/suspend/reboot.
15 KB (2,262 words) - 19:23, 29 July 2010
-
# Press the Power button until the phone powers on and displays the boot menu
... set to Host mode and the other one set to Device mode. One Neo could give power to the USB-port it the other Neo's battery is low. ''(I have to verify this
34 KB (5,408 words) - 08:30, 10 February 2012
-
...timized like below 240x320 it's work like a charm and to quit just use the power button.
11 KB (1,764 words) - 09:14, 23 May 2011
-
...stem]]. It's connected to the VB power rail (battery terminal voltage) for power and thus needs to be powered off separately from the main system.
The audio power output may vary as the battery discharges:
1 KB (196 words) - 11:11, 18 August 2008
-
You have to be careful about selecting the power source for
which provides a spare power regulator. But keep in mind that it is steered by i2c.
2 KB (350 words) - 08:19, 4 September 2009
-
=== Getting neo1973 GTA04 GSM to recover properly after power down ===
Every time after you power off the gsm:
5 KB (719 words) - 14:41, 27 December 2009
-
* uses less power (GPS shall not be turned on, the cell info is already available)
9 KB (1,482 words) - 07:41, 3 September 2008
-
|AGPS (3G only), 2 megapixel camera, 4 buttons (power, volume up, volume down, mute, Home), [http://www.tuaw.com/2007/09/10/iphon
6 KB (878 words) - 21:22, 20 August 2010
-
...led) is some kind of 'detector'. Works with USB adapter cable, external AC power supply, most likely car cirgarette charger, but not with those small 1.5V '
4 KB (639 words) - 17:16, 2 August 2009
-
...All of this can be done from the MicroSD card, while user simply adds more power to the telephone device turning it into a powerful 400Mhz PC.
11 KB (1,818 words) - 21:28, 18 June 2009
-
...NAND controller, MMC/SD host, [[I2C]] and IIS interfaces, Memory & Clock & Power management controllers, RAM.
...50606]] || Works || (Aka PMU) Fakes the battery charge level (set at 88%), POWER button, etc. Also contains an RTC, also unused by Linux.
35 KB (5,125 words) - 08:42, 10 February 2012
-
==Power Sources==
===V12 Embedded power source===
12 KB (1,974 words) - 02:56, 26 July 2009
-
...Boot lader|boot loader]]. This probably isn't what you want. Let the phone power up first.
10 KB (1,686 words) - 16:58, 24 September 2011
-
power the device up, become root, and run
9 KB (1,378 words) - 08:40, 10 February 2012
-
No power switching (usb 1.0)
Port 1: 0000.0103 power enable connect
32 KB (3,433 words) - 12:23, 31 August 2008
-
==== Disable power management ====
... apparently get upset by power managed devices, and the Freerunner enables power management of the wifi by default to preserve battery. One user's wrt54g ce
15 KB (2,133 words) - 09:38, 10 March 2011
-
...глая, размещена рядом с USB разъемом. [[Neo1973 Power button/ru | фото кнопки]].
...о неизвестно, но можете посмотреть [[Neo1973 Power Management#Approximate_power_draw_of_various_subsystems|примерную
30 KB (1,285 words) - 17:01, 30 August 2008
-
A: No suitable low power open source WiFi device was available when the [[Neo1973]] was designed. A
A: There has been no word on this so far, but see [[Neo1973 Power Management#Approximate_power_draw_of_various_subsystems|these estimates]] f
13 KB (2,003 words) - 17:02, 30 August 2008
-
==== Power Management ====
The '''gta01_pm_gsm''' driver implements GSM power management (this means, if this is compiled as a module, you have to load t
13 KB (1,671 words) - 22:32, 20 August 2008
-
...按下[[Neo1973 AUX Button]] 你可以循环使用选单项目。使用''POWER''按钮选取其中的项目。
13 KB (947 words) - 13:36, 1 February 2010
-
* Power button press
...t 30mA additional standby current, since we cannot properly switch off the power supply to the S3C2410 PLL's. There is nothing we can do to change this wit
11 KB (1,314 words) - 08:45, 23 August 2008
-
The CPU is put into a low power mode where it still has enough compute power to take the signal from the microphone, divide it into
833 B (143 words) - 12:24, 31 August 2008
-
... Even when on standby. May be just on button press or some gesture to save power. Screen would be on just for 2 seconds or so.
* Power saving...
811 B (120 words) - 12:26, 31 August 2008
-
A: In der Designphase des Neo1973 gab es kein passendes "low power open source" WiFi device. Ein nicht offenes WiFi Modul hätte die Entwi
...bt es keine Abschätzung über die Nutzungsdauer, klicke [[Neo1973 Power Management#Approximate_power_draw_of_various_subsystems|hier]] für ein
16 KB (2,514 words) - 19:36, 15 November 2009
-
* Power button press
...t 30mA additional standby current, since we cannot properly switch off the power supply to the S3C2410 PLL's. There is nothing we can do to change this wit
12 KB (1,727 words) - 23:15, 22 August 2008
-
neo1973 power-off
then Power-off, and enter the Bootmenu to test the new Entry.If you can boot from NAND
24 KB (4,075 words) - 08:12, 10 February 2012
