Debug Board v1
From Openmoko
(Difference between revisions)
HaraldWelte (Talk | contribs) (→Questions) |
HaraldWelte (Talk | contribs) (→Usage instructions) |
||
Line 21: | Line 21: | ||
== Usage instructions == | == Usage instructions == | ||
− | + | === Connectors === | |
+ | |||
+ | ==== Debug cable to phone ==== | ||
+ | Use the flat ribbon-cable to connect to the phone. | ||
+ | # The wide end is for the Debug board, the narrow end for the phone | ||
+ | # For both sides: | ||
+ | ## Lift the brown lever of the connector on the PCB | ||
+ | ## Place the copper contacts on the bottom (brown surface facing to the top. | ||
+ | ## Insert the ribbon cable as far as possible into the connector (it won't go in all the way, that's normal) | ||
+ | ## Close the brown lever to lock the ribbon cable | ||
== Questions == | == Questions == |
Revision as of 19:55, 3 January 2007
Contents |
Hardware Components
- RTL8xxx Ethernet MAC
- This adds network connectivity during development
- Two 7-segment LED displays
- Two DB-9 headers
- Serial Console (level-shifted to true RS232 levels)
- ?
- One DB-25 header
- ?
- One 2x10pin 2.54mm header
- JTAG Port
Schematics
http://people.openmoko.org/sean_chiang/Debugboard.pdf
http://people.openmoko.org/sean_chiang/top.pdf
http://people.openmoko.org/sean_chiang/bottom.pdf
Usage instructions
Connectors
Debug cable to phone
Use the flat ribbon-cable to connect to the phone.
- The wide end is for the Debug board, the narrow end for the phone
- For both sides:
- Lift the brown lever of the connector on the PCB
- Place the copper contacts on the bottom (brown surface facing to the top.
- Insert the ribbon cable as far as possible into the connector (it won't go in all the way, that's normal)
- Close the brown lever to lock the ribbon cable
Questions
- Can it also be connected to GTA01v4 ?
Bugs/Problems
see http://bugzilla.openmoko.org/cgi-bin/bugzilla/buglist.cgi?product=Debug+Board