User:Shulyaka
From Openmoko
(→3D-printed case attempt) |
|||
Line 6: | Line 6: | ||
The part shown on photos is printed by i.materialise in polyamide. The part fells as strong as the original one (even the small details are good) but not finished very well which is not a big issue. | The part shown on photos is printed by i.materialise in polyamide. The part fells as strong as the original one (even the small details are good) but not finished very well which is not a big issue. | ||
− | I will provide the | + | I will provide the sources when I'm ready to release them. |
[[Image:DSC03831.JPG|400px]] | [[Image:DSC03831.JPG|400px]] |
Revision as of 21:52, 8 February 2012
3D-printed case attempt
This is my first attempt to create a complete case using 3d printing technology without sacrificing buttons and the hole. My work is based on official Openmoko CAD files as well as on Lukas Märdian's work (http://blog.slyon.de/2012/01/02/building-a-case-for-the-goldelico-gta04/).
The first attempt was unsuccessful: the hole was too big and couldn't fit. However I'm not giving up.
The part shown on photos is printed by i.materialise in polyamide. The part fells as strong as the original one (even the small details are good) but not finished very well which is not a big issue.
I will provide the sources when I'm ready to release them.