GTA01 revisions
From Openmoko
(New page: = GTA01 specification = * Neo 1973 (GTA01B_v4) * Battery (1200mAh) * Stylus * Headset * Phone Pouch * Lanyard * SanDisk 512MB MicroSD Card * Mini USB Connectivity Cable And as from GTA01Bv...) |
Revision as of 18:47, 16 August 2008
Contents |
GTA01 specification
- Neo 1973 (GTA01B_v4)
- Battery (1200mAh)
- Stylus
- Headset
- Phone Pouch
- Lanyard
- SanDisk 512MB MicroSD Card
- Mini USB Connectivity Cable
And as from GTA01Bv1:
- Bluetooth (;
GTA01v3
First generation of prototypes that was given to internal OpenMoko software developers.
Unfortunately not useful at all due to non-working touchscreen.
- ATAG_REVISION: 0x0000130
GTA01v4
Second generation of prototypes that was given to Harald +Mickey.
Unfortunately still not useful due to half-working touchscreen.
- ATAG_REVISION: 0x00000140
GTA01Bv1
This is the bluetooth-enabled fork of GTA01
GTA01Bv2
This is the first produced version of the bluetooth-enabled version.
- ATAG_REVISION: 0x00000220
GTA01Bv3
This is the second produced version of the bluetooth-enabled version. It contains mainly GPS-related fixes.
- ATAG_REVISION: 0x00000230
This is the version that is shipped in Phase 0.
GTA01Bv3 Errata
PMU unable to resume from suspend
Due to use of wrong GPIO/EINT pin, the PMU cannot wake-up the phone after suspend. This means, specifically, the following events can not bring the phone back from suspend-to-ram:
- PMU RTC Alarm
- Power button press
- Charger events (charger insertion/removal/error)
- Low battery
Stand-by time extremely low
This is due to a design bug resulting in at least 30mA additional standby current, since we cannot properly switch off the power supply to the S3C2410 PLL's. There is nothing we can do to change this with post-production fixes. GTA01Bv4 will address this issue.
GSM doesn't resume phone from suspend
The GSM modem currently doesn't signalize a wakeup interrupt to the S3C2410 in case there's some noteworthy event, such as incoming call, loss of network, incoming SMS or the like.
This is a serious issue, but can be fixed with a GSM Modem Firmware update.
GSM Sidetone too loud
The local feedback sidetone (see [1]) is too loud. This will be addressed in a GSM firmware update
Bad block
Due to an error in the production process, the factory-programmed NAND bad block information has been lost. This means that some blocks in the flash will wear out rapidly, which might become as bad as rendering the device unusable.
GTA01Bv4
This is the version that is being shipped in Phase 1
Looks
This is what the GTA01Bv4 PCB looks like without the shielding cans, which will be fitted later.
Errata
There were two versions of GTA01Bv4: some were given away (red mainboard), and some were sold (green mainboard). The given-away have one transistor too many.
Changes from GTA01Bv3
- Fix all Errata items from GTA01Bv3
- Add I2C, SPI and one irq and wakeup capable GPIO pin to debug port plus have test pads for all these signals (for soldering wires directly on the pcb)
- Fix a number of production related details and minor hardware details that are not user-visible