View source for Debug Board v1
From Openmoko
You do not have permission to edit this page, for the following reasons:
You can view and copy the source of this page:
Templates used on this page:
Return to Debug Board v1.
You do not have permission to edit this page, for the following reasons:
You can view and copy the source of this page:
Templates used on this page:
Return to Debug Board v1.
Debug Board |
|
---|
Outdated warning ! This article or section is significantly outdated, either by significant hardware or software changes. Procedures mentioned in this page may well not work for current hardware/software. |
This debug board was used internally at Openmoko.
Use the flat ribbon-cable to connect to the phone.
There's a Connecting GTA01Bv2 with Debug Board foto story ;)
NOTE: Please see Debug Board#Errata below!
S5 (small white button in corner of PCB) is a reset button. If you press it, it resets the device.
FIXME. We never tried to make them work.
There currently is no software/driver support for the Ethernet port in Openmoko. Please stay tuned.
FIXME. Nobody has successfully tried to make it work.
The debug board and GTA01Bv2 try to drive the same line (GSM_EN) which switches between serial console and GSM Modem. To resolve this conflict (and give ownership of that signal to GTA01), you need to unsolder both R105 and R106. Those resistors are located very close to the 2x10pin JTAG header.
see http://bugzilla.openmoko.org/cgi-bin/bugzilla/buglist.cgi?product=Debug+Board